User Manual

(A) (B) (C) (D)
21
Remote Control
Control Panel
on fireplace insert
Other Important Features
● Please be aware that when heater stops working, air will continue to blow for several
seconds. This helps protect the internal wiring from overheating.
● If the temperature inside the electric fireplace becomes abnormally high, the
temperature protection mechanism will activate automatically and the heater will be
shut down. If this happens, the fireplace will not operate. To remedy this problem,
remove the power cord from the power outlet and wait 3-5 minutes for the heater to
cool down or until the temperature protection mechanism deactivates. Then, plug the
power cord back into the power outlet to resume normal operation.
● 1,500 watts / 5,200 BTU per hour / Provides supplemental heat for up to 92.9 sq m or
999.9 sqft.
Grounding Instructions:
This heater is suitable for 120 volts. The cord has a plug as shown in FIGURE A.
An adaptor (not included) as shown in FIGURE C can be used to connect three-blade grounding-
type plugs into two-slot receptacles. The green grounding plug extending from the adaptor must
be connected to a permanent ground such as a properly grounded outlet box. The adaptor
should not be used if a three-slot grounded receptacle is available.
When L indicator is on, the heat is at low level.
When L and H indicators are on, the heater is at high level.
When indicator is on, the Bluetooth is paired.
When indicators are off, heater stops and Bluetooth is not paired.
Grounding methods
Grounding Pin
Cover of Grounded
outlet Box
Metal Screw
Ground Means
Grounding Pin
Adaptor