User Manual

20
《DOWN》Use in conjunction with the TIMER and HEATER modes. Controls the TIMER and
THERMOSTAT settings. When in the TIMER mode, pressing the DOWN arrow will decrease
the timer setting by 30 minutes each time the arrow is pressed (settings from 30 minutes to10
hours). Pressing the DOWN arrow will decrease the timer setting by 1 hour each time the arrow
is pressed (settings from 10 hours to 12 hours). When in the HEATER mode, pressing the
DOWN arrow will decrease the thermostat setting by 1°C / 1°F each time the button is pressed
(settings from 15.5°C-36°C / 60°F-97°F). Note: Display 15°C-36°C in Celsius on all devices.
To activate the Child Lock press and hold the UP and DOWN buttons at the same time. A single
"beep" indicates the Child Lock has been activated and the control panel is inoperable. To
deactivate the Child Lock, press and hold the UP and DOWN keys at the same time. Three
"beeps" indicates that the Child Lock has been deactivated.
This fireplace features a "Calibration" function which allows you to adjust the Thermostat reading
so that it matches the thermostat in your home. To calibrate, press and hold the TIMER button
for a few seconds until the display shows 00F. Then, press the UP or DOWN key to adjust the
Thermostat reading to the desired level. The calibration function has an adjustment range of
+9°C to -9°C / +9°F to -9°F.
Operation reminder: When the room temperature is higher than the temperature set on the
thermostat, the heater will shut off. To run the heater without using the thermostat function press
the 《HEATER》button one time.
Please refer to the digital display panel for working status of electric fireplace.
Change from Fahrenheit to Celsius
When the fireplace is turned on, the default setting for the temperature is Fahrenheit. To change
to Celsius, press and hold the 《HEATER》button for 3 seconds on either the control panel,
remote control or [ golden specie ] APP on your smart phone.
OPERATING INSTRUCTIONS