User Manual

● Always purchase the correct size and grade of battery most suitable for the intended use.
● Always replace the whole set of batteries at one time, taking care not to mix old and new
ones, or batteries of different types.
● Clean the battery contacts and also those of the device prior to battery installation.
● Ensure the batteries are installed correctly with regard to polarity (+ and -).
● Remove batteries from equipment which is not to be used for an extended period of time.
● Remove used batteries promptly.
● For recycling and disposal of batteries to protect the environment, please check the internet
or your local phone directory for local recycling centers and/or follow local government
regulations.
Warning - The Fireplace must be properly installed before it is used.
Please reference attached operating instruction on remote control and control panel
《ON/OFF》Turns the flame and logs On/Off.
《DIMMER》Controls the brightness of the flame and logs.
《HEATER》 Controls the functions of the heater. Press the button once to set the heater to
HIGH (1,500 W). Press the button twice to set the heater to LOW (750 W). When the heater is
already running on HIGH, press the button once to change the setting to LOW and press twice
to turn the heater OFF. When the heater is already running on LOW, press the button once to
turn the heater OFF, and press twice to turn the heater to HIGH.
《FLAME》 Controls the color of the flame. The default setting for the flame color is YELLOW.
Each time the flame button is pressed, the color of the flame will change. The last setting is one
which causes the flames to automatically and continuously cycle through all colors, changing
every 15 seconds. Pressing the FLAME button one more time will return to the first (default)
flame color of YELLOW.
《SPEED》Controls the speed at which the flame effect turns. There are 5 speed levels. The
default speed is level three. There are two slower speeds and two faster speeds which can be
set by pressing the SPEED button.
《SPOT LIGHT》 Controls the brightness of the accent lights. Press once to set the accent light
at the highest level. Touch again to reduce the brightness. Press a third time to turn the accent
light off.
《TIMER》Controls the duration of the heater timer. To set or adjust the timer, press the TIMER
button then press the “UP” or “DOWN” arrows. The timer is adjusted in 30 minute increments
(settings from 30 minutes to 12 hours) each time the “UP” or “DOWN” arrow is pressed.
《UP》Use in conjunction with the TIMER and HEATER modes. Controls the TIMER and
THERMOSTAT settings. When in the TIMER mode, pressing the UP arrow will increase the
timer setting by 30 minutes each time the arrow is pressed (settings from 30 minutes to10
hours). Pressing the UP arrow will increase the timer setting by 1 hour each time the arrow is
pressed (settings from 10 hours to 12 hours). When in the HEATER mode. Pressing the UP
arrow will increase the thermostat setting by 1°C / 1°F each time the button is pressed (settings
from 15.5°C-36°C / 60°F-97°F). Note: Display 15°C-36°C in Celsius on all devices.
CAUTIONS: BATTERY INSTRUCTIONS
OPERATING INSTRUCTIONS