User Manual

․ This fireplace utilizes sparks and arcing in its internal operation. NEVER use this device in
areas where gasoline, paint, or other flammable liquids are used or stored.
․ Always plug heaters directly into a wall outlet/receptacle; never use with an extension cord or
relocatable power tap (outlet power strip)
․ NEVER burn wood or other materials of any kind in this fireplace.
․ Always use a licensed electrician for any maintenance to this device.
․ Always use properly grounded, fused, and polarized outlets.
․ Always use ground fault protection where required by local electrical code.
․ Always disconnect the device from its power source before moving the device or performing
any cleaning or maintenance.
․ To avoid damage when transporting or storing this fireplace, always keep both the insert and
its power cord in a dry place and free from excessive vibration.
․ DO NOT tangle power cord with cords of other appliances when in use.
․ Use this fireplace ONLY as described in this manual. Using this device in a manner other than
recommended by the manufacturer may cause fire, electric shock, injury to persons, and/or
damage to property.
․ Do not operate any heater after it malfunctions. Disconnect power at service panel and have
heater inspected by a reputable electrician before reusing.
․ To disconnect heater, turn controls to off, and turn off power to heater circuit at main
disconnect panel.
․ To prevent a possible fire, do not block air intakes or exhaust in any manner.
․ Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the heater.
․ The remote control requires 2-AAA batteries.
․ DO NOT mix old and new batteries.
․ DO NOT use rechargeable silver oxide cell batteries with remote control unit.
․ DO NOT mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel-Cadmium) batteries.
․ DO NOT dispose of batteries in fire. Improper disposal may cause batteries to leak or explode.
․ To reduce the risk of fire, do not store or use gasoline or other flammable vapors and liquids in
the vicinity of the heater.
․ To disconnect heater, turn controls to off, and turn off power to heater circuit at main
disconnect panel.
․ To prevent a possible fire, do not block air intakes or exhaust in any manner.
․ Warn that the heater must be properly installed before it is used.
․ If the product is not used for a long period of time, please unplug the power cord from wall outlet
to assure safety.
․ Minimum installation external dimension:
119.3 cm * 52.2 cm * 38.2 cm / 47 in * 20.6 in * 15in
● Minimum installation internal dimension:
123 cm * 60cm * 38.2 cm / 48.4 in * 23.6 in * 15in
SAVE THESE INSTRUCTIONS
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents.
Tools Required for Assembly (not included): Phillips screwdriver