User's Manual

FCC Requirement
Note: This equipment has been tested and found to comply with the limits .pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protectionagainst harmful interfer
ence in a residential installation. This equipment generates, uses, and can radiate radio frequenc
y energy, and if not installed and used in accordance with the instructions,may cause harmful in
terference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help.
RF exposure considerations
This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled
environm ent. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
RF Exposure - This device is only authorized for use in a mobile application. At least 20 cm of
separation distance between the module and the user's body must be maintained at all times.
A label must be affixed to the outside of final com m ercial product with the following statements:
This device contains FCC ID: 2A62U-M FAPEG- 2
Consistent with §2.909(a), the following text must be included within the user’ s manual or operator
instruction guide for the final com m ercial product
This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled
environm ent. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
This device is only authorized for use in a mobile application. At least 20 cm of separation distance
between the module and the user's body must be maintained at all times.
The final host / m odule combination may also need to be evaluated against the FCC Part 15B
criteria for unintentional radiators in order to be properly authorized for operation as a Part 15
digital device. The FCC Part 15 Statement shall be included in the user manual of final commercial
product if applicable.
CAUTION: Any changes or modifications not expressly approved could void the user’ s authority to
operate the equipment.