Installation Instructions

①

②

③

④

⑤

⑦

⑧

⑨

⑩

1.Connect the light cap

with the iron pope by

spinning clockwise,

2.Then connect the iron

pipe with the other iron

pipes by spinning

clockwise,

3.At last , connect iron

pope with the lamp base

by spinning clockwise.

⑥

Shade

4.Fix the upper and lower

iron hoop on the shade in one

5.Then roll the two iron until

the shade end to end

6.At last dign the

end of shade and press it

Bulb

7.Place the lamp cover

atthe bulb interface

8.Install the bulb

Modle name: MJFL2020050601

FCC ID: 2AW4JMJFL2020050601

PAGE 1
Modle name: MJFL2020050601 FCC ID: 2AW4JMJFL2020050601 ① 1.Connect the light cap with the iron pope by spinning clockwise, ② ⑨ 2.Then connect the iron pipe with the other iron pipes by spinning clockwise, ③ ⑩ Bulb 7.Place the lamp cover atthe bulb interface 8.Install the bulb Shade 4.Fix the upper and lower iron hoop on the shade in one ④ ⑥ B 3.At last , connect iron pope with the lamp base by spinning clockwise. ⑦ 5.Then roll the two iron until the shade end to end ⑤ ⑧ 6.
PAGE 2
Federal Communications Commission Notice This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.