User's Manual

PM3.0*25mm screw and a M3 screw nut. Then install the rain gauge onto the rain gauge holder, and
establish them with two PA3.0*8mm screws:
4．Press a M3 screw nut into the nut slot of the small side of the wind sensor holder, insert wind sensor
holder onto the transmitter holder, establish them
with a PM3.0*22mm screw:
5.Insert the wind direction component into the wind speed component, and then insert the wind direction
RJ45 into the 623K hole of the wind speed component. Insert a M3 screw nut into the big side of the
wind sensor holder, and then install the whole wind sensor onto the holder, establish them with a
PM3.0*22mm:
6.Open the battery compartment, install the rechargeable batteries, then cover the battery door. Insert
the whole transmitter onto the long side of the transmitter holder, and establish them with a
PM3.0*18mm screw. At last, insert the wind speed wire RJ45 into the "WIND" 623K hole of the
transmitter:
7.① Put the rain gauge wire across the waterproof tower case, and then insert the RJ45 into the 623K
hole of the solar component;