Instruction Manual

medium level / 2 beeps, high level / beep 3 beeps), after reaching the highest gear, it will cycle from low to
high. Press and hold the hot compress button for 3 seconds to turn off the heating output. The duration of a
single use is limited to 15 minutes.
9. Memory Function：
Save memory: In the power-on state, after adjusting the EMS mode, strength and hot compress level,
press and hold the “Strengthen the Intensity” button on the remote control for 3 seconds to automatically
memorize the current parameters. At the same time, the buzzer will beep once for a reminder that the
parameters have been memorized.
Recall the memory: In the power-on state, press and hold the “Lessen the Intensity” button on the remote
control for 3 seconds to automatically recall the memory parameters. At the same time, the buzzer beeps
once, and the massager starts working according to the recalled parameters.
(Note: The memory function is a single set of memory, that is, when the current parameters are
memorized, the last saved parameters are automatically overwritten. After restarting the power, the product
will automatically enter the waiting state, and the last saved parameters can be used only after recalling the
memory)
10. Remote control pairing:
Plug in the charger to make the product in the charging state, and press any button on the main unit and
the remote control at the same time, the product buzzer beeps long, indicating that the remote control is
successfully paired.
Warm prompt
 The product will automatically shut down after 15 minutes of operation. It is recommended
to use the same part for no more than 30 minutes a day, and use it as needed every week.
 After use, this product should be stored in a ventilated and dry place out of the reach of
children.
 Please handle this product and its parts with care, and do not use violence.
 please select to meet the requirements of the iec60601-1 standard power adapter for
charging equipment.
Cleaning and maintenance
 When the massager is dirty, wipe it with a dry soft cloth or dry towel.
 Please clean the conductive electrode frequently. You can wipe it with a soft cloth or soft
towel moistened with a little water and wrung out; if it is dirty, wipe it with a soft cloth
moistened with a little medical alcohol (75% concentration).
 Turn off the machine before cleaning, and prevent water or other liquids from entering the
product to prevent short circuit and electric shock.
Parts List