Instruction Manual

5. Prompt of Battery Level:
When you press and hold the switch button to turn on,
or press the switch button or any button on the remote control during charging, you can judge the remaining
battery power according to the following tips:
① The indicator light flashes once and the buzzer beeps once: it means the remaining power is less than
30%.
② The indicator light flashes twice and the buzzer beeps twice: it means that the remaining power is bet
ween 30% and 70%.
③ The indicator light flashes 3 times and the buzzer beeps 3 times: it means that the remaining power is
between 70% and 100%.
When detecting that the battery power is too low, the buzzer will emit a rapid beep every 2 seconds, an
d it will automatically shut down after 30 seconds.
6. EMS Mode Adjustment:
There are 3 modes. Press the mode button on the remote control to cycle between the three modes. At
the same time, the buzzer will emit corresponding sound (mode 1/ sound 1, mode 2/ sound 2, and mode 3/
sound 3). Long press the mode key for 3 seconds to turn off the EMS output.
Daily mode 1: Suitable for daily neck massage
Relaxation mode 2: Suitable for stiff and sore neck
Strong mode 3: Suitable for chronic cervical strain
7. EMS Strength Adjustment:
① It is controlled by the switch button on the main machine, and there are 6 levels of force adjustment:
After starting up, The EMS defaults to mode 1. Short pressing the switch button once can increase the
output strength of EMS by 1 level (range from 1 to 6), and at the same time, the buzzer makes a short sound.
After pressing the highest gear, the indicator will flash 2 times and the buzzer will make 1 sound long,
indicating that the gear has reached the highest level. If you press the button again, it will start from level 1
again and increase upward.
② Controlled by remote control, there are 15 levels of force adjustment:
Press the " Strengthen the Intensity" button on the remote control: press once to increase the gear, and at
the same time, the buzzer will make a short sound. After reaching the highest gear, press the " Strengthen
the Intensity " button again, and the indicator light will flash 2 times. The buzzer will make a long sound,
indicating that the gear has reached the highest level.
Press the " Lessen the Intensity" button on the remote control: press once to reduce the gear, and the
buzzer makes a short sound. When it reaches the lowest gear, press the button again, and the indicator light
will flash 2 times. The buzzer makes a long sound, indicating that the gear has reached the lowest. And at
the same time, the EMS output closed.
8. Regulation of Hot Compress Mode
There are 3 levels in the hot compress mode: low level (about 38°C), medium level (about 40°C), and high
level (about 42°C). Press the hot compress button on the remote control, and each time you press it
increases by one level, and the buzzer sounds at the same time Corresponding beeps (low level / 1 beep,