User Manual

Turn ON： In the state of power-off, press and hold the power button for 1, the headset will send
out two “di-di” Prompt tones and blue LED will be on ; the blue and red LED light will glitters in
turn if holding power button for 2 sec ; there will be 4 “du-du” rising Prompt tone if holding for 5
seconds.
Turn OFF： In the state of power-on, press and hold power button for 5 seconds till the red LED
light glitters three times. There will be four "dodo” voices from loud to low. Now the unit is
turned off.
Pairing： In the state of power-off , press and hold power button for 3s until red and blue LED
light glitters in turn, the headphone enters into pairing mode. In this case, the headset can be
paired with the Bluetooth enabled devices.
※Usually，Setup procedure relates to the “setup”,” connection” or “Bluetooth” menu in your
cellphone, click “search for Bluetooth device”, your cell phone will find out headphone
name ”513” or other pairing name and ask if you want to connect, then click “confirm” or “yes”.
Afterwards, input pairing password or PIN code ”0000” and click ”yes” or “confirm”, the
headphone will connect with your Bluetooth device successfully.
※The headphone will enter in power-on mode if releasing power button before red and blue LED
light glitters in turn. In this case, please turn off the power and operate it once again.
Answering calls: Press the power button once to answer the incoming calls.
Dialing calls: If the headset is paired with the cell phone, dialing the numbers on the cell
phone will enable the conversation on the headset automatically.
Ending calls: Ongoing conversation on cell phone can be ended by pressing the power key
once. .
Redial latest number: The cell phone will automatically dial the last dialed phone number by
double pressing power key on the Bluetooth headset. We can hear the prompt tone from the
headset.
Volume control: In the state of music or calls, move volume button upwards to increase the
sound and move it downwards to decrease the sound.
Wired headphone Function
The headphone can be used as the wired headphone. Just simply attach 3.5mm audio cable.
In the state of power off: It can be used as the wired stereo headphone by inserting the
3.5mm audio cable. Please adjust the volume of sound sources when it is as the wired
headphone. In this case, the volume control of the headphone can' t be workable.
■Symbol of LED Light ：
Charging--- The red light is on. The blue light will be on when it is full of power after charging.