User's Manual
JWH-C2
Quick Start Guide
Attention
Product View
Product Feature
Packing component
Specification
BT/Line in/ FM mould
Volume +/-,previous(FM previous channel )and next songs(Fm next channel)
USB charging and firmware update
Audio notification
Indicators
Bluetooth function
Please read the following attention for using correctly and keep the speaker life better
:
Please use the speaker in usually environment.
Hight altitude falling may destroy the speaker.
Please don’t try to tear the speaker by yourself,or cleaning it with chemical solvent.
Don’t use it loudly for long time in case to hurt your ears.
Please turn off the speaker if long time no use.
Model: JWH-C2
Size: 185*108*46mm
Bluetooth protocol : Bluetooth V2.1+EDR(A2DP)
Transmission range :﹤10M(transmission distance is different by different environmental)
USB charge: DC 5V
Speaker:2*2“
Power: 2*5W
Audio source selection:AUX IN &Bluetooth & FM
Frequency range:120HZ-18KHZ
Buit-in lithium abttery: 7.4V/2000mAh
Playing time: about 6hours(volume50%,affected by the volume and the audio content)
Bluetooth Speaker
Lithium battery bulit in, please don’through out or put it in fire
Can't connect the speakers
Ensure that speakers into pairing mode
Sure phone in a reasonable range of bluetooth use, under environment without sunscreen,
the largest bluetooth connection distance is about 10 meters
Restart and set the cell phone bluetooth pairing and connecting
Ensure that speakers into pairing mode. If the blue light is not flashing quickly, please restart
your speaker until the blue indicator light flashing rapidly to get into pairing mode again.
If the blue light is flashing quickly, show that speaker is in pairing mode.
Phone support A2HP protocol, Windows and apple system compatible bluetooth driver
If computer/phone/tablet system upgrades and hardware is not compatible, cause the
speaker bluetooth can't identify or is unable to use normally, seller afford irresponsible.
Unable to connect the computer to charge
Try to replace the USB cable or restart the computer.
power saving mode
Once connected ,audio didn't work in 10 minutes , bluetooth stereo get into deep sleep,
wake up must restart the power supply once.
When the device connected with the bluetooth devices , other phone unable to connect it.
when mobile phones connect to other bluetooth devices . For connection with this
equipment, please close the other bluetooth devices, and then restart it.
speaker(1pc)、quick start guide(1pc)、USB cable(1pc)
Operation
1.
long press power button
in the same time,BT LED flash quick and audio notification
(speaker get into BT mode automatically without AUX in). short press power button,speaker
get into FM mdole.
1. get BT mode, speaker paired automatically last device in 30s. the BT LED shall be flash
quick when waiting for pair or no pair(smartphone different the connection shall be bit different)
1. Speaker switch to Aux mode automatically when you plug Aux in wire.
2. Signal source come from different devices (MP3/phone/PC etc), enjoy your music.
2. open your BT device,searching speaker,smartphone shall show “JWH-C2”,choose
it,get pairing, waiting for a while the BT LED flash slowly then it paired, in the same time
audio notification.
3. enjoy your music after paired BT mode.
4. when call is coming, you can choose anwser or refuse it by phone or speaker.(maybe a bit
different base on different BT device,some smartphone connected to BTautomatically).
When playing, press
“ ”to get to play or pasue.If FM model, long press it go to search
Automatic(fist use)
short press“ “or“ ”key then can get previous or next song.(only suit BT mould)
battery working time shall be different base on Vol, speaker wil power off automaticall when low power
shall be charged in time.need to charge at least one time per month to keep battery life
.
turn the Volume knob then can adjust Volume down or up(right side is up)。
when calls coming,press then anwer call,long press it more than 2S then refuse,
when in calling,short press it then end of the call. long press it more than 2S then disconnect BT.
Volume adjust
through USB cable connect PC or any 5V DC adaptor to get charge.LED red when charing.charing
time about 4H. the red LED off when full charged.
the LED on the Vol knob flash when power on,speaker waiting for pair.speaker paired or
speaker working when the LED solid blue.
speaker in charging the battery LED red, red off then full charged.
FAQ
Sounds different
please check whether over the valid distance, or there are barrier between speaker and device.
Volume +/-
Pause/play
Pull
BT LED
Next
Previous
Handle free
Power/Charging LED
MIC
AUX in
MicroUSB port
How to connection
Aux in Mode Operation
PLAY/PAUSE
Previous/Next
Charging speaker
LED Indicator
Battery