User's Manual

5
2. RF4200 软件操作说明
2. RF4200 Software Tuning Instruction
2.1 读取工作参数
2.1 Working Parameters Reading
2.1.1 有线调试的接线方式
2.1.1 Cable Connection Method
使用 RS232 串口线连接计算机与 RF4200 主板，安装 RS232 串口驱动程序，并
在计算机上打开 CardMonitor.exe 软件，点击 (Refresh)按钮，选择正确的 COM
号，点击 (Open)按钮打开串口，软件会自动识别主板类型，主板参数配置如图
1-1 所示。如果有的参数没有显示，可以点击 (Read)按钮。
One way is the usual on site tuning. Use RS232 cable to connect PC to RF4200
board, install RS232 driver, open the software CardMonitor.exe, click Refresh button
, select the correct Port COM, click Open button , then the software will
automatically recognize the model number of the board, and shows the factory’s
setting parameters as bellow (Figure 1-1). If some parameters are not showed, click
Read button , then all parameters will be showed.
Figure 1-1