Instruction Manual

Jack Bluetooth Speaker
and Wireless Charging Pad
Instruction Manual
1 x Bluetooth® Speaker (7198-50)
1 x USB to Micro-USB Charging Cable
1 x Instruction Manual
Playing time: up to 2.5 hrs at max volume
Charging time: up to 2 hrs
Pairing Name: “Jack BT”
(Be sure to fully charge the speaker before
using for the rst time).
Charging the Speaker
Connect the provided charging cable to a
power source and to the micro USB port on
the speaker (3).
The LED indicator light will glow red when
charging and turn off when fully charged.
Bluetooth
®
Setup:
Turn ON/OFF switch to the ON position,
LED Indictor will ash BLUE.
Turn on the Bluetooth function on mobile
device, Select “Jack BT” pairing name.
LED will glow BLUE if successfully paired
Speaker will automatically pair if the mobile
device has been paired before.
Press and hold ON/OFF button to turn off
the device
Wireless Charging:
Connect the provided charging cable to
a power source, place wireless charging
supported mobile device on top charging
pad.
Device will begin to charge automatically
The unit’s full performance is achieved
only after 2 or 3 completed charge and
discharge cycles.
To reduce the risk of injury, close
supervision is necessary when the product
is used near children.
Do not expose the device to moisture.
Do not use the device in excess of its
output rating. Overload outputs above
rating may result in a risk of re or injury.
Do not use the device if damaged or
modied.
Damaged or modied batteries may exhibit
unpredictable behavior resulting in re,
explosion or risk of injury.
Do not disassemble the device. For
repairs, seek a qualied service
professional. Incorrect reassembly may
result in a risk of re or injury.
Do not expose the device to re or
excessive temperature. Exposure to re
or temperatures above 104°F may cause
explosion.
Ensure that qualied service professionals
use only identical replacement parts to
ensure product safety
WARNING-When using this product, basic
precautions should always be followed:
Read all the instructions before use.
Never store or use this product in
temperatures below 32°F(0°C) or above
115°F(45°C).
Do not overcharge Phone. Unit may get
hot with excessive use. Remove Phone
when it is fully charged. Never charge for
more than 7 hours at a time.
1.
•
2.
•
•
*
•
3.
•
•
4.
5.
6.
7.
8.
9.
10.
11.
12.
•
1.
2.
3.
1.
2.
3.
4.
•
•
•
Wireless Charging Pad
Micro USB Port
LED Indicator
ON/OFF Switch
What’s included:
Functions:
T
ech Specications
Instructions:
SAFETY PRECAUTIONS:
MADE IN CHINA
Changes or modications not expressly
approved by the party responsible for
compliance could void the user’
s authority to
operate the equipment.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
FCC Statement:
B96
has been evaluated to
general RF exposure requirement.
can be used in portable
without restriction.
This equipment general uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC
rules. Operation is subject to the following
two conditions (1) this device may not cause
harmful interference, and (2)this device must
accept any interference received, including
interference that may cause undesired
operation.
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be
installed and operated with minimum distance
20cm between the radiator and your body.