RF ANT Switch LED CH KEY Lock Shock intensity motor strength Shock vibration buzzer remote control
Remote control 1) Power on When the battery is fully charged, turn the power-on knob, the backlight of the LCD screen will light up, if the receiver is not paired, the dog logo No. 1 in the upper left corner of the LCD screen will flash until the receiver is paired.
change the shock level (1-99), the LCD backlight will light up when rotating, release the "Shock Strength Key" after the change is complete. 7) Lock and unlock the remote control In the case of power on, toggle the "lock push" up and down, the backlight of the LCD screen will light up, and a lock will be displayed on the screen. If the lock is successful, if you need to unlock it, you can turn the "lock push" in the reverse direction.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
