User Instructions

Remote control
1) Power on
When the battery is fully charged, turn the power-on knob, the backlight of the LCD screen will
light up, if the receiver is not paired, the dog logo No. 1 in the upper left corner of the LCD
screen will flash until the receiver is paired.
2) Pairing
When the remote control is turned on, first turn on the receiver in pairing mode (when the
receiver LED keeps flashing green rapidly), briefly press the "CH button" of the receiver, after
the receiver "DI" beeps once, the pairing is successful. Enter the connection state, the default
matching dog No. 1 (if you need to match No. 2-4, you can check the switching instructions),
when the No. 1 dog icon in the LCD is no longer flashing, you can issue a command.
3) Switch dogs 1-2
In the power-on state, first press the "CH key" (do not release), and slowly rotate the power-on
knob at the same time, you can switch the dog, and the LCD screen backlight will light up
when it is rotated. After switching is completed, release the "CH key". The switching
performance is the switching of dog icons 1~4 on the upper left of the LCD.
4) Reminder (buzzer prompt)
When the connection between the remote control and the receiver is completed, short press
the "buzzer prompt button", the green light on the remote control will flash once, the LCD
screen backlight will light up, the receiver will flash the green light once, and send out a "DI"
reminder dog dog.
5) Vibration and adjust the vibration level
When the connection between the remote control and the receiver is completed, briefly press
the "vibration prompt button", the green light of the remote control will flash once, the LCD
backlight will turn on, the receiver will flash the green light once, and vibrate according to the
current vibration level.
After pressing and holding the "motor strength key", slowly rotate the power-on knob to change
the vibration level (1-9), the LCD backlight will light up when rotating, release the "motor
strength key" after the change is complete.
6) Electric shock and adjustment of electric shock level
When the connection between the remote control and the receiver is completed, short press
the "Shock Button", the red light of the remote control flashes once, the LCD backlight lights up,
the receiver will flash the red light once, and send out shock pulses according to the current
shock level.
Short press the "Shock intensity", the red light of the remote control flashes once, the LCD
screen backlight will light up, the receiver will flash the red light once, and send out an
electric shock according to the current electric shock level plus 1 levels (the highest level is 19).
After pressing and holding the "Shock Strength Key", slowly rotate the power-on knob to