Products Map How to operate ‐‐Turn on power button ON the transmitter and receiver.
‐‐‐‐Press on the pair button of the receiver, And the Led indicator status will turn to green. Then it will be paired automatically. Please no worried that led color is different when unit (receiver and transmitter) is paired.
‐‐Please turn off the power button of unit（Both the transmitter and receiver）and put the them back to the power case each time after you use it. Charging function ‐ If the unit’s battery is running low, The led indicator of unit (both receiver and Transmitter) will flash green. ‐You can charge the wireless units directly by using the Micro‐B USB Y cable (included) ‐When unit is fully charged, the charging function will be shut down automatically.
the led indicator of receiver turn to green ‐‐ Press and hold the pair button of transmitter 2‐3 seconds, Then the Led indicator Will flash a while and start to the pair mode. The led indicator of Transmitter will turn to blue (No Flash) after 25 seconds, Then Pair mode is completed. Note: The Led indicator of transmitter will only flash 25 seconds, So Please completed this step within 25 seconds.
What’s in box 1. Receiver x 1 Transmitter X 1 2. Micro‐B USB Y cable 3.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
