Specifications

5.耐候性能
WEATHERING
PERFORMANCE
跌落试验
Drop test
在遥控器装有电池的条件下 ，不带包
装，从80cm 高度自由跌落在不小于
3cm厚木板上，遥控器的跌落面应与
冲击面平行，每个面(共6个面)各跌
落三次
Under the condition of remote
control with batteries, without
packing, free fall on a height
of 80 cm on the plank thicker
than 3cm, the fall of the remote
control surface should be
parallel to the strike face,
each side ( total 6 sides) fell
three times
结构应无断裂，功能应正常
The structure should be faultless,all
functions should be normal
符合
耐温水
Heat water resistance
能耐60℃的温水，60℃的温水滴在遥
控器表面三个不同的部位上包括字符
图形符号部位，用软布擦干
It can withstand 60 degrees of
warm water, 60 degrees of warm
water dripping on the surface of
the remote control three
different parts including
characters and symbols , then
wipe with soft cloth.
遥控器的表面色调不应起变化 ，字符标志不应
被擦掉
The surface color of the remote control
should not change, and character marks
should not be erased.
符合
字符、标志、涂饰部
分的附着力
The adhesion of characters,
signs, and finishing parts
用粘附力为2‐3.5N/cm的透明胶带粘
遥控器的字符、标志和涂饰部分
Use the adhesive tape with 2 to
3.5N/cm to stick the character,
logo and finishing part of the
remote controller.
无脱落现象
No shedding phenomenon
符合
耐溶剂性
Solvent resistance
1.用浸有20%的食盐水、无水乙醇分
别擦拭遥控器表面三个不同部位上包
括字符图形符号部位 30次
Wipe three different parts on
the surface of the remote
control respectively with 20%
salt water and anhydrous
ethanol, including the symbol
parts of characters and figures
30 times
2.将食用油用滴管滴在遥控器表面三
个不同部位包括字符图形符号部位 ，
1h 后用软布擦干
Drop the cooking oil into three
different parts on the surface
of the remote control, including
the characters and symbols. Dry
with a soft cloth after 1h
表面硬度和外观无异常 ，字符图形符号清晰
There is no abnormal surface hardness and
appearance, and the characters and
symbols is clear
符合
FCCStatement:
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and
can radiate radio frequency energy and,if not installed and used in accordance with the instructions, mav cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.