Manual

Position Control Mode : 0 ~ 320˚ possible but recommended range is within 0 ~ 300˚
Speed Control Mode : Continuous rotation possible with rotation speed control
Manufactured using Super Engineering Plastic, our servos are highly durable, impact resistant
and designed to withstand even the high torque stress levels that go beyond the tolerance
specs of Engineering Plastic Gears.
Durability
Using Multi Drop TTL Full Duplex UART Serial communications protocol with maxium speed
of 0.667Mbps, single command can set the speed, position, LED, operational compliance,
stop and operational status of up to 254 servos simultaneoulsy at once.
Communication
Operational parameters such as speed, calibration, compliance to external force, LED could be
set by writing directly to the register, by using the Servo Manager downloaded from the web site
or by using the Servo Manager Kit sold separately.
54 Operating Parameters
By controlling the torque according to the discrepancy between the goal position and the
actual position, Compliance Control provides certain measure of elasticity to absorb the shock
from the external force.
Compliance Control
Data feedback from the internal temperature, position, and overload sensors.
Data Feedback
Maximum Operating Angle
Internal temperature sensor monitors the motor and the circuit temperature and issues Overheating
Protection Error if the temperature moves beyond set value.
Overload Protection Error is issued when the load stress on the servo goes beyond the set value.
These safety features protec the sevo from the potential damage and prolongs the servo life.
Protection Features
0.325 degrees resolution provides very accurate smooth control and minimal vibration.
Resolution
7