Manualshelf

User's Manual

ManualsBrandsDongbu Daewoo Electronics ManualsLED & LCD TVs42" PDP Monitor
21222324252627282930
Parts of the remote
controller
23
16. ADD/DEL: Use to add or delete channels to/from
memory.
17. SLEEP: Sleep Timer setting.
SLEEP TIMER: Off
15min 30min 60min 90min
120min OFF
Note: If an active signal is not present for about 30 minutes,
the set will automatically turn to ST-BY mode.
18. CCHB:
Displays the available channels in sequence. (These
buttons change sub-channels in the DTV only.)
19. PIP: Select either PIP / POP On or Off.
20. SWAP: Swap the main screen for sub screen.
21. SOURCE: Sub Screen input mode change as follows PIP
table mode or POP table mode.
22. POSITION: Move the sub window position in PIP mode.
Position: left bottom
left top right top right bottom
23. PICTURE MODE: Picture modes change as follows:
Normal
Dynamic Cinema User Normal
24. SOUND MODE : Using this button, Select the desired
sound mode.
Normal
Movie Music News User Normal
Note:
SOUND MODE can be selected only SOUND EFFECT is off.
25. MTS: In Analog, you can select sound mode
(Mono/Stereo/SAP). In Digital, you can select
audio tracks (English/Spanish/French).
Note: The availability of audio track depends upon the program.
26. SOUND EFFECT: Using this button, Select the desired
sound effect.
Off
BBE M. Voice Off
Inserting Batteries into the Remote Control Unit
To load the batteries, turn the remote control handset over
and open the battery compartment. Insert the batteries (Two
1.5v, type AAA). Make sure that the polarity matches with
the (+) and (-) marks inside of the battery compartment.
Note:
To avoid damage from possible battery leakage, remove
the batteries if you do not plan to use the remote control
handset for an extended period of time.