User's Manual

<depend on the phone>
2. Select the device (MDMTEC 1100 o).
The phone displays the passcode entry screen.
3 Enter the passkey (0000).
The phone displays “PIN verified,”
Note: Some phones ask you to accept the BT link. Enter Yes.
Upon successful completion, connection is complete.
Placing a Call with the Bluetooth Hands free Car Kit
To place a call, you must first establish a Bluetooth link between the car kit and your phone .
You can place a call with the car kit in these ways:
• Dial a number from the phone, placed in a call, some phone press “vc/pt(phone diagram)”.
• Digit dial and press “HF” with UIRC(remote controller).
• Press “VC/PT” with UIRC [phone voice name] (depend on the phone).
• Use the Speed Dial with UIRC(remote controller , only 2 digit).
• Use last number redial from UIRC(remote controller). Some phone press the “HF” twice
When connected, all of these calls are hands free.
Answering a Call
When you receive an incoming call, the system responds:
Audio system will be muted, LED will blink, display “ VOICE IN” or “TEL MUTE”
• The system plays beep tone
To answer an incoming call:
1 Press the HF button.
2 If you want to answering a call automatically.
You press and hold “STOP” button for two seconds, when system not on a call.
The system responds automatically after 10 seconds.
Caution: This function reset with key ignition off.
i.e. If you want to answering a call automatically press and hold “STOP” button for two
seconds, after every ignition on
The system responds automatically after 10 seconds.
Ending a Call