User's Manual

Additional Pairing
To pair additional phone to the system, with the car kit and phones in close proximity:
Action
1 Press and hold the transfer button (phone diagram) in the Remote Control Keypad more 2
seconds until beep tone is generated.
caution : Also you can disconnect your phone-> press and hold transfer button (phone
diagram) button in the Remote Control Keypad more 2 seconds until beep tone is
generated.
2 When prompted, display “TEL MUTE or VOICE IN” on the audio display for 4seconds.
Set your phone in scan mode and enter “0000” when prompted for the passcode.
3 When the phone displays the device name (MDMTEC 1100), select the device.
The phone displays the passcode entry screen.
4 Enter the passkey (0000).
The phone displays “PIN verified,”
Note: Some phones ask you to accept the BT link. Enter Yes.
Upon successful completion, connection is complete.
caution : Originally, it is allowed the Bluetooth handsfree to get paired 3 phones to the
maximum, In case the Bluetooth device in the phone failed to search for the Bluetooth car kits,
Please erase Bluetooth car kit from your phone (Paring & Connection, both of them).
Sometimes phone will not operate properly, then power off & on your phone.
And then pairing
Removing a connected phone
Press and hold “VC/PT”(PHONE diagram) button in the Remote Control Keypad more 2
seconds until beep tone is generated.
. Caution: This function reset with key ignition off.
i.e. If you turn on the ignition , the latest paired phone will be paired automatically.
Changing a paired phone
1. Press and hold “VC/PT”(PHONE diagram) button in the Remote Control Keypad more
2 seconds until beep tone is generated, LED is on. If led is on, then select the
device(depend on the phone).