User's Manual

SLEEP FUNCTION
This Alarm Clock
can be set to play music for a set amount of time (10-60 minutes) and then
automatically turn OFF using the SLEEP Timer.
To turn the SLEEP Timer function ON simply press the SLEEP button (4) and “90” will show
on the LED Display indicating the music will automatically turn OFF after 90 minutes.
To adjust the amount of time before the music will turn OFF, press the SLEEP button (4)
repeatedly until the correct amount of time (90 – 80 -70 – 60 – 50 – 40 – 30 – 20 – 10
minutes) is shown on the LE
D Display.
To turn the SLEEP Timer OFF continue pressing the SLEEP button (4) until the LED Display
shows “OFF”.
BATTERY INSTALLATION FOR POWER BACKUP - Requires 2 AAA Batteries (Not
Included)
In case of a Power failu
re, the Battery Backup will keep the Clock & Alarm times accurate
until the main power has been restored.
During a power failure the LED display will remain OFF until power has been restored.
NOTE: Batteries are not required for normal use of this clock. The purpose of the Battery
Backup is to insure the correct Time & Alarm settings are stored in the Clock Memory in the
event of a power failure.
• Open the Battery Compartment by gently pushing the tab on the compartmen
t door
in
the direction indicated on the bottom of the clock.
• Insert 2 AAA batteries (not included) following the + / - polarity as indicated in the
compartment.
• Replace the door to the Battery Compartment and make sure it properly clicks in
place.
NOTE: Do not force the door as breakage may occur.
TROUBLESHOOTING
Symptom
Possible Cause
Solution
Alarm did not sound
- Alarm was not properly turned
ON.
- Alarm was not set to the correct
Time (AM / PM)
- Check the LED Display Lights
to insure the correct Alarm is
turned ON
- Check the Alarm Time reset
as necessary
No sound
- Clock not in correct Function.
- Volume set at minimum
- Press the FUNCTION button
(1) to the desired Function
(Bluetooth, FM, AM).
- Increase Volume.
Time is Flashing
- Power Loss
- Reset the Time
9