Operating Instructions

WiFi 30A Operating instructions

If you want to control your water pump and dust collector by WiFi 30A,you need to pair the

switch to your transmitter first.

1. How to clean code: press the paring button 8 times , light flashes,cleaning code completely

2.How to set working mode:

Powen on the switch first

*Momentary mode:Press the "pairing button" 4 times fast,red led light on,then press the

transmitter button, red light blinks fast ,then off.

(press remote button, switch on;release button,switch off)

*Toggle :Press the "pairing button" 2 times fast,red led light on,then press the transmitter button,

red light blinks fast ,then off.

(press remote button, switch on;press again,switch off)

*Latched mode:Press the "pairing button" 3 times fast,red led light on,then press the transmitter

button A, red light blinks fast ,then press button B,red light blinks fast,then off.

(press remote button A, switch on;press button B,switch off)

PAGE 1
WiFi 30A Operating instructions If you want to control your water pump and dust collector by WiFi 30A,you need to pair the switch to your transmitter first. 1. How to clean code: press the paring button 8 times , light flashes,cleaning code completely 2.How to set working mode: Powen on the switch first *Momentary mode:Press the "pairing button" 4 times fast,red led light on,then press the transmitter button, red light blinks fast ,then off.
PAGE 2
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.