User's Manual

10 / 24
3.1.2 Tie rope
Fig. 2 Schematic Diagram of Rope
1. Put the thin end of the rope through the hanging hole.
2. Put the thicker end of the role through the thin end.
3. Tighten the rope.
3.2 ON/OFF
Turn On: after installing batteries, press ON/OFF Button to turn on the equipment. Enter into the
measurement interface after the system starts.
If the Pulse Oximeter does not detect the finger within 8 seconds, it will automatically shut down.
4 Measurement
4.1 Alarm
1．Carefully check the measurement part before wearing the Pulse Oximeter. Do not wear the Pulse
Oximeter to the damaged skins or tissues.
2．Do not place the Pulse Oximeter on the side of body with artery catheter or intravenous injection tube.
3．Do not put the Pulse Oximeter and blood pressure cuff on the same side of body as the blood flow
occlusion during the course of blood pressure measurement may affect the reading of blood oxygen saturation.
4.2 Measurement Procedures
1．Press ON/OFF Button to turn on the Pulse Oximeter;
2．Open the finger clip, put the finger into cavity, and then release the finger clip. Make the display screen
above the finger clip when putting the finger.
As shown in the figure below: