Technical Specs

General Notes:
⚫ When the transformer is turned off the fixture light will turn of, then PIR function become
active and converts to battery power.
⚫ PIR Function is only active after the sensor detects the environmental brightness at less than
50LUX at night.
⚫ When the sensor detects the environmental brightness of less than 50LUX, plus PIR detects
motion, the deck light will turn on and stay on for 1 minute before turning off.
⚫ When the sensor detects the environmental brightness higher than 200LUX, after a 90
second delay time, deck light will turn off. The purpose of setting 90 second delay is to
prevent the 200LUX brightness caused by a flash of lightning or car light.
Pairing via DIP Switch
- If operating only one fixture, place the fixture in its permanent location.
- To operate multiple fixtures, please pair the fixtures before installation, follow the PAIR steps
below:
⚫ There is a DIP switch in the back of fixture, the 4 bottons on the switch can be slided to up
and down. The fixtures with the switch bottons in the exactly same setting will be paired as
a group . You can make up to 16 groups.
⚫ When at Off mode (0000), fixture is at off status, will not pair.
⚫ When at Test mode (1111), fixture will turn on after detecting motion whenever at day or
night, then turn off after 3S of delay.
⚫ If Pairing lost efficacy, press the Reset botton for 1S, the light will turn on for 10s, then turn
off, reset succeed. You can start a new pairing.