Technical Specs

Technical Specifications

⚫ Power Supply: 12VAC -15VAC

⚫ Non-removable battery: 3.7V 800mAh

⚫ Normal battery charge time: 4 Hours, indicate light will be green once fully

charged

⚫ Motion Sensor Range: Up to 15 ft. (varies with surrounding temperature)

⚫ Sensor Detection Angle: 90°

⚫ Electrical Requirements: 12VAC - 15VAC

⚫ Light Bulb: Integrated LED

⚫ Installation Height: Ideally, 0.9M (3 ft.) above the ground.

⚫ Minimum to Maximum Outdoor Outdoor Temperature: -20°to 50°Celsius

(-4°to 122°Fahrenheit)

⚫ Distance between fixtures: 10M (30 ft.)

⚫ Group member : up to 8 fixtures

⚫ Pair Signal: 2.4 GHZ

⚫ Water Proof: IPX6

⚫ PIR Delay Time : 1 minute

Setting Up and Operating Multiple PIR Deck Lights

What to know before intall:

1. Decide which PIR Deck Lights will be grouped (up to 8 fixtures)

2. Open the plastic cover on back of each PIR Deck Light.

3. Refer to the “Pairing via DIP Switch’’ Step to pair the deck lights.

4. Close the plastic cover (to prevent water go inside fixture)

PAGE 1
Technical Specifications ⚫ Power Supply: 12VAC -15VAC ⚫ Non-removable battery: 3.7V 800mAh ⚫ Normal battery charge time: 4 Hours, indicate light will be green once fully charged ⚫ Motion Sensor Range: Up to 15 ft. (varies with surrounding temperature) ⚫ Sensor Detection Angle: 90° ⚫ Electrical Requirements: 12VAC - 15VAC ⚫ Light Bulb: Integrated LED ⚫ Installation Height: ⚫ Minimum to Maximum Outdoor Outdoor Temperature: -20°to 50°Celsius Ideally, 0.9M (3 ft.) above the ground.
PAGE 2
General Notes: ⚫ ⚫ ⚫ ⚫ When the transformer is turned off the fixture light will turn of, then PIR function become active and converts to battery power. PIR Function is only active after the sensor detects the environmental brightness at less than 50LUX at night. When the sensor detects the environmental brightness of less than 50LUX, plus PIR detects motion, the deck light will turn on and stay on for 1 minute before turning off.
PAGE 3
FCC Warning Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.