Specifications

17
Installation, Operation and Maintenance Manual
PowerCore
®
Dust Collectors – Series CPV
MAINTENANCE
Figure 5 Filter pack replacement (CPV-4 illustrated)
Filter pack replacement
Use safety and protective equipment when removing contaminants and
filter packs.
Dirty filter packs may be heavier than they appear.
Use care when removing filter packs to avoid personal injury.
Do not drop filter packs.
Refer also to Figure 5.
1 Turn off and isolate any air movement equipment associated with the process
(e.g. fan) and check clean air chamber is at atmospheric pressure.
2 Turn off controller and/or compressed air supply.
3 Open access door by releasing fasteners. Swing door fully open and engage
door locking mechanism.
4 Release filter pack retainer wing nuts and remove filter pack retainers.
5 Remove each filter pack by lifting straight up.
6 Insert new filter packs into place.
7 Install filter pack retainers and tighten wing nuts so that each filter pack
gasket is seated firmly.
8 Disengage access door locking mechanism, then close and fasten access
door.