Operation Manual

DO230SR

If you are working on a very dirty area, you can move the brush over the area slowly,

several times. If it is a wood ﬂ oor, move fast to avoid heat or moisture build up in the

wood. By cleaning with the cloth over the brush, you will not affect the shine on the

ﬂ oor.

To strip wax

Use ﬂ oor brush for open areas, detail brush for corners or tight areas – no towel, slow

strokes. Work a small area at a time – remove the emulsiﬁ ed wax from the ﬂ oor. When

all of the wax has been stripped, immediately clean the ﬂ oor and brushes with water

before residue has a chance to harden on them. Go back over the stripped area with the

ﬂ oor brush with a towel to remove any remaining residue before waxing.

To clean waxed ﬂ oors

Wrap clean towel around the ﬂ oor brush, brush quickly. This will cause the dirt to be

removed, but not the wax.

Vinyl ﬂ oors

Do not allow the heat to build up on any kind of vinyl, since it can soften it enough to

affect its texture. Work fast on vinyl.

Tile ﬂ oors

Use the concentrator with the detail brush attached to an extension. Have the ﬂ oor

brush with cloth attached ready as well. Clean the grout between the tiles with the

detail brush. Remove the detail brush and attach the ﬂ oor brush, move the brush across

the ﬂ oor to clean the tile and remove excess moisture and residue. For areas of tile

that are very dirty, remove the towel and agitate with the brush. Do not let the area dry

before you wipe with a towel.

Spot cleaning (carpets)

Use the concentrator with or without the detail brush. Move slowly over the soiled

area, allowing the steam to penetrate. Agitate with detail brush or clean towel. Dab the

spot with the towel (do not rub). Repeat as necessary to remove stain. Vacuum only

after the carpet has completely dried.

Always test colour fastness of carpet in an inconspicuous area before cleaning. If your

Ultra Steam Shark II fails to remove stubborn stains a commercially available carpet

shampoo may be required.

Do not add cleaning solutions, scented perfumes, oils or any other chemicals to the

water used in this appliance as this may damage the unit or make it unsafe for use.

Upholstery

Use the ﬂ oor brush attached directly to the hand grip with a clean white terry cloth.

Use fast, light strokes to avoid getting the fabric wet. Be patient with stubborn spots.

Work on a spot gently for no more than a minute at a time, then wait ﬁ ve minutes for