Operation Manual
DO230SR
FILLING YOUR STEAM CLEANER
IMPORTANT
: When there is no more water in the steam cleaner, the steam will stop.
Step 1
Make sure to remove the plug from the socket before fi lling the steam
cleaner.
Step 2
Screw off the safety fi ll cap by turning it anti-clockwise.
Step 3
Place the funnel in the fi ll opening and fi ll the water tank with 1.2 l water.
Place the safety fi ll cap back on the unit by turning it clockwise. The heat up time is
about 8-10 minutes when you fi ll with cold water. When you fi ll with warm water the
heat up time will shorten.
Step 4
Place the plug in an earthed socket of 230V. The red indicator light will light
up.
Step 5
Wait approximately 8 – 10 minutes until the steam reaches the correct
temperature and pressure.
Step 6
Attach the accessory you want to use to the fl exible tube.
Step 7
In the beginning water will come out of the tube, which is normal. This is
unheated water in the tube.
ATTENTION
: Always remove condensation water from the tube before use or when
the appliance hasn’t been used for a long time. The tube can be emptied in a container
or in the sink by pressing the button. When the tube is empty it can be used again.
Never direct the tube towards persons, animals or plants.
IMPORTANT
: Make sure the plug isn’t in the socket when fi lling the unit for the fi rst
time or when refi lling it.
ATTENTION
: let the unit cool down for about 15 minutes before refi lling it again.
When the unit gets fi lled when it is still hot the fi rst drops of water can splash out. Be
very careful when opening the safety fi ll cap: the cap can get hot during use and the
escaping steam can cause burns.
Filling the steam cleaner with water
Step 1
Remove the plug from the socket.
Step 2
Press the steam button and keep it pressed in until all pressure is gone from
the boiler.
Step 3
Unscrew the safety fi ll cap carefully by turning it counter clockwise, so all
remaining steam can escape. When all hissing has stopped and the last steam has
disappeared you can remove the safety cap. Let the appliance cool down.
ATTENTION
: Let the appliance cool down for 15 minutes before refi lling it. Filling
the appliance when it is still hot can cause the water to splash out and cause burns.
Therefore always be very careful when fi lling the appliance and opening the safety fi ll
cap. The safety fi ll cap can get very hot during use and the escaping steam can cause