User Manual

21
DO223S
www.domo-elektro.be
EN
· Empty the dust container.
· Remove the lters from the dust container and clean them under running water. Do not use hot water
or detergent.
· Let the lters dry and replace them in the dust container. Make sure the lters are completely dry
before using the appliance again.
UV LIGHT
· To guarantee an optimal functioning of the UV light, the lamp needs to be cleaned regularly. Make
sure you will not leave any nger prints on the lamp after cleaning, as this can inuence the operation
of the lamp.
· Remove the screws and the cover of the UV light.
· Clean the lamp using a soft, dry cloth.
· Replace the cover and the screws after cleaning.
· In case of a defect of the lamp, contact the after sales service. The lamp needs to be replaced by the
repair service.
ROTATING BRUSH
· To remove the cover of the rotating brush, loosen the screws and press the tabs of the cover.
· Remove dirt and hair from the brush. If necessary, use scissors.
· Replace the cover and the screws after cleaning.