Operation Manual

DO220SR

Moving too slowly can dry out the soap scum and cause it to granulate on the surface.

The surface will have a gritty feel. If this happens, apply vapor to the surface with the

bristle brush again and re-clean.

Garden Furniture

Use the brushes depending on the surface area. Work quickly when cleaning resin

outdoor furniture. Finish by wiping with a towel.

Blinds

Use the nylon bristle brush to clean blinds. Move the brush over the surface, allowing

enough time for the vapor to penetrate. Work quickly on PVC blinds. Test for color

fastness on fabric blinds before using. Finish by wiping with a towel.

Automotive

For detailing the wheels, use the concentrator and the bristle brush. Exterior windows

are cleaned best by applying the vapor with the concentrator and following with a

paper towel.

To clean bicycles, use the bristle brush.

To clean equipment, use the bristle brush, depending on the surface area. Finish by

wiping down with a towel.

Articial Plants

Use the concentrator without a brush attached to blow off the dust and dirt.

Clothing

A vapor cleaning system is excellent for removing wrinkles from fabrics. Simply

“vaporize” the surface from a distance (30-45 cm). The dry vapor removes wrinkles

without leaving the fabric wet like ordinary fabric steamers do.

Nicotine and Tar

Nicotine and tar dissolves at high temperatures and becomes a light yellow oil that

has the consistency of sewing machine oil. When the nicotine/tar lm is touched by

steam pocket, it immediately dissolves and ows into the steam pocket towel. You can

remove it from at surfaces as fast as you can move the steam pocket over the surface.

Removing Wax, Tar, Etc.

Many stains are only stuck on the surface of materials and can be easily and quickly

removed by “blowing” excess material away from the surface from the side. This is

accomplished by using the concentrator. Hold the terry cloth towel to the side to catch

the loose residue as it is blown by the concentrator. Note: Always vacuum any loose

residue off the surface before you apply vapor to it.