Instruction manual

DO151A

FUNCTIONS

STOP-LO-MI-HI

Press the LO button for a low wind speed, the MI button for a medium speed and the

HI button for high speed. Press the STOP button to stop the air ow.

TIMER

Set the timer knob to I to switch on the air cooler (stand-by).

Set the timer knob to 0 to switch off the air cooler.

Turn the timer knob from 0 to 120 to set the timer, with a maximum of 2 hours (120

minutes).

WIND

By pressing the WIND button, the vertical air vent will move from left to right to

spread the air ow.

COOL

Make sure that there is clean water (and ice packs if preferred) in the water tank before

using the cool function. When you press the COOL button, the water pump will pump

water to the honeycomb lter to obtain a cool air ow.

NEGATIVE IONS

When the air cooler is switched on, the negative ions will start working to purify the

air from dust.

CLEANING AND MAINTENANCE

• Remove the plug from the socket before cleaning the appliance.

• Remove the honeycomb lter. Clean the lter every 1 or 2 months if the

environment is susceptible to dust and dirt. Wash the lter in slightly soapy water,

with a soft cloth. Rinse well, so that all soap residues are removed. Let the lter

dry for at least 4 hours before placing it back into the air cooler.

• The dust lter can be cleaned with water and a soft brush. Dry thoroughly before

placing it back.

• Clean the water tank once a month for an optimal and hygenic performance.

Empty the water tank through the drain hole by pulling out the drain plug and dry

thoroughly.

• Regularly vacuum the air vent at the front to remove dust. Or wipe clean with a

damp cloth.