Operation Manual

DO8808H
brush, as otherwise the airfl ow will be obsturcted to such an extent that the thermal
cutout will operate.
Keep your hair away from the immediate vicinity of the air inlet opening.
Please check the cable for damage from time to time ! In the event of any necessary
repair, including replacement of the mains lead, your appliance should be sent to the
specialist retailer from whom your hair dryer was acquired.
Do not attempt to repair the hair dryer or replace a damaged supply cord yourself.
Improperly carried out repairs can expose the user to considerable hazard. Please take
the hair dryer to a local service centre for repairs or replacement.
USER INSTRUCTIONS
The hair dryer has 3 heat/speed settings to enable quick and effective drying and
styling.
O = off
1 = moderate temperature and speed for more controlled drying and styling.
2 = high temperature and speed for quick drying all the excess moisture off your hair.
T
= cold
Detachable air concentrator : concentrate airfl ow from spot drying or styling smaller
section of hair.
Caution : the concetrator will inevitably become hot during use.
Dual voltage selector
Check the position of the voltage selector switch before use (remove mains plug and
use a coin to move the switch to the correct position).
Set to 127V for voltages ranging fom 100-127V.
Set to 220V for voltage ranging from 220-240V.
CLEAN AND CARE
Always disconnect the hair dryer before cleaning.
Never immerse the hair dryer in water.
It is suffi cient to wipe the exterior over with a damp cloth and then wipe dry.
A soft dry brush may be used to remove dust and hairs from the air inlet grill, to
ensure proper airfl ow at all times.
13