Quick Start Guide

SOL8SDR-P Quick Start Guide

Revision 1.0

Page 1

Item

Connection

Lemo 4-way jack

Connect 12V power via CA0002 or CA3172.

RJ45 8-way jack

Connect to a PC or network Ethernet port.

SMA 50 ohm jack

RF-A COFDM antenna.

SMA 50 ohm jack

RF-B COFDM antenna.

DIN 1.0/2.3 jack

SDI-1 video input. Connect CA2396 DIN 1.0/2.3 to BNC adaptor.

DIN 1.0/2.3 jack

SDI-2 video input. Connect CA2396 DIN 1.0/2.3 to BNC adaptor.

PAGE 1
SOL8SDR-P Quick Start Guide No Item Connection 1 Lemo 4-way jack Connect 12V power via CA0002 or CA3172. 2 RJ45 8-way jack Connect to a PC or network Ethernet port. 3 SMA 50 ohm jack RF-A COFDM antenna. 4 SMA 50 ohm jack RF-B COFDM antenna. 5 DIN 1.0/2.3 jack SDI-1 video input. Connect CA2396 DIN 1.0/2.3 to BNC adaptor. 6 DIN 1.0/2.3 jack SDI-2 video input. Connect CA2396 DIN 1.0/2.3 to BNC adaptor. Revision 1.
PAGE 2
SOL8SDR-P Quick Start Guide The SOL8SDR-P IP address can be established using DTC’s Node Finder application. If DHCP settings need to be disabled and a fixed address applied, right click on the device to reconfigure. Double click the device on Node Finder to open web browser communications. On authentication, leave the Username blank and enter the Password as Eastwood. Go to the Configuration>Preset>Encoder tab and set the Video Source and Format to match the attached camera.