Installation manual

ManualsBrandsDomino ManualsProjectorSim2

7 KEYBOARD PAD

8 REMOTE CONTROL

Insert the batteries, taking care to match the polarity, as

indicated in the battery recess of the remote

(Fig. 22)

four 1.5V

AAA alkaline

batteries

Change the batteries in the remote control if experiencing

difficulty in sending commands to the projector.

If the remote control is not to be used for a long period of time

remove the batteries. Replace all batteries at the same time;

do not replace one new battery with a used battery. If the

batteries have leaked,

carefully wipe the

case clean and

replace with new

batteries.

The remote control

sends commands to

the projector via

infrared signals.

It is possible to control

the projector by

pointing the remote

control at the screen;

the sensor at the front

of the projector will pick up the reflected infrared commands.

(Fig. 23)

Avoid placing obstructions between the remote control and the

infrared sensor at the front of the projector; this will impair the

remote control performance.

Eight push buttons, at the rear of the projector, will allow complete operation without the use of the remote control.

Fig. 22

Fig. 23

Up/Down/Left/Right arrow keys

Navigate through and make adjustments to the On

Screen menus.

Arrow Up/Down switch on from stand-by and recall

Source Selection menu.

Switches off to stand-by.

Activates the On

Screen Display

menus. Navigates

Menu pages.

-Focus-Esc

De-activates the On Screen Display and gives access to

the lens Zoom/Focus adjustment functions.

Auto

Selects Auto

Adjust

(automatic

optimisation of the

displayed image).

Downloaded From projector-manual.com Sim2 Manuals