User manual

Select the required programme by
means of the programme selector dial
(9)
Turn the programme selector dial to the re-
quired programme. The selector can be
turned either clockwise or anticlockwise.
The green light of button "Start"
starts to
flash.
On programme progress display the pilot
lights corresponding to all phases compos-
ing the selected programme are lit.
On position
the programme is reset and
the machine is switched OFF.
At the end of the programme the selec-
tor dial must be turned to position
to
switch the machine off.
Important! If you turn the programme
selector dial to another programme when
the machine is working, the lights in the
programme progress display will start to
flash to indicate a wrong selection. The
machine will not perform the new selected
programme.
Select the spin speed, Rinse Hold or No
spin option (8)
Select the spin speed, Rinse Hold option or
No Spin option by turning the spin speed
selector.
• The position 1000 is equivalent to 900
rpm for the synthetic and wool pro-
grammes and 700 rpm for the delicate
wash programme.
• The position 500 is equivalent to 500 rpm
for the synthetic and wool programmes
and 450 rpm for the delicate wash pro-
gramme.
Rinse hold
By selecting this option the water of the last
rinse is not emptied out to prevent the fab-
rics from creasing. When the programme
has finished, the lights "End" and "Door
locked" are lit to indicate that the water
must be emptied out (See: " At the end of
the programme").
No spin
By selecting this option all the spinning
phases are excluded. To be used for ex-
tremely delicate material. The machine will
add some additional rinses to the cotton
and synthetic programmes.
For the maximum spin speed allowed by
each programme, refer to the chapter
"Washing programmes".
Select the desired option by means of
buttons 2, 3, 4 and 5
Depending on the programme, different
functions can be combined. These must be
selected after choosing the desired pro-
gramme and before pressing the button
"Start"
. The relevant light will illuminate.
If an incorrect option is selected, the corre-
sponding indicator lamp flashes for about 2
seconds. For the compatibility of the op-
tions with the washing programmes, refer
to the chapter «Washing programmes».
Start the programme by pressing
button 6
To start the selected programme, press this
button; the corresponding pilot light stops
flashing and remains lit.
On programme progress display the pilot
lights "Washing"
and "Door locked"
illuminate to indicate that the appliance
starts operating and the door is locked.
Altering an option or a running
programme
It is possible to change any option before
the programme carries it out.
Before you make any change, you must
pause the washing machine by pressing the
button 6.
The programme can be changed as long as
the button 6 has not been pressed. Chang-
ing a running programme is possible only
by resetting it. Turn the programme selector
dial to
and then to the new programme
position. Start the new programme by
pressing the button 6 again.
Interrupting a programme
Press the button 6 to interrupt a pro-
gramme which is running, the correspond-
8