User manual Washing Machine WMD 1050
Contents Safety information Product description Control panel Before first use Daily use Helpful hints and tips Washing programmes 2 3 5 7 7 9 11 Care and cleaning What to do if… Technical data Consumption values Installation Environment concerns 12 14 16 16 16 20 Subject to change without notice Safety information Important! Read carefully & keep for future reference. • The safety of Your appliance complies with the industry standards and with legal requirements on the safety of appliances.
• • • • • and drain hose and the worktop is not pressing the electrical supply cable against the wall. If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance. Always be sure, that there is no water leakage from hoses and their connections after the installation. If the appliance is installed in a location subject to frost, please read the “dangers of freezing” chapter.
Machine front 1 2 1 2 3 4 Detergent dispenser drawer Control panel Door opening handle 4 adjustable feet 1 2 3 4 Transit locking devices Drain hose Electrical lead Inlet hose 3 4 Machine rear 1 2 3 4
Detergent dispenser drawer Compartment for powder or liquid detergent used for main wash. If using liquid detergent pour it just before starting the programme. Compartment for liquid additives (fabric softener, starch). Any fabric softener or starching additives must be poured into the compartment before starting the wash programme. Prewash detergent is to be added straight into the drum.
= Prewash = Start/Pause = Washing = Cycle End = Rinses = Door Locked = Spin = Rinse Hold = Delicate = No Spin = Wool = Cotton = Drain = Cold = ON/OFF = Synthetic Extra Quick Very short programme for lightly soiled laundry, except for wool. The washing time will be reduced approx. 30 minutes for cotton and by 20 minutes for synthetic. The machine will perform 1 rinse less. Quick By selecting this option the washing time will be reduced approx. 10 minutes.
Programme Selector Dial It allows you to switch the appliance on/off and/or to select a programme. Before first use Warning! Ensure that the electrical and water connections comply with the installation instructions. Important! Remove any material from the drum. any residues which may have been left by the manufacturing process. Pour approx. 100 ml of detergent straight into the drum and run a cotton cycle at 60°C. When the programme is finished the machine will be ready to use.
Select the required programme by means of the programme selector dial (9) Turn the programme selector dial to the required programme. The selector can be turned either clockwise or anticlockwise. starts to The green light of button "Start" flash. On programme progress display the pilot lights corresponding to all phases composing the selected programme are lit. the programme is reset and On position the machine is switched OFF.
ing light starts to flash. Press the button again to restart the programme. Cancelling a programme position to canTurn the selector dial to cel a programme which is running. Now you can select a new programme. Opening the door after the programme has started First set the machine to pause by pressing the button 6. After some minutes, the door can be opened, when the following conditions are observed: • The water temperature is below 55°C. • The water level is below the bottom edge of the door.
Rub particularly soiled areas with a special detergent or detergent paste. Treat curtains with special care. Remove hooks or tie them up in a bag or net. Maximum loads Recommended loads are indicated in the washing programme charts. General rules: • Cotton, linen: drum full but not too tightly packed; • Synthetics: drum no more than half full; • Delicate fabrics and woollens: drum no more than one third full. Washing a maximum load makes the most efficient use of water and energy.
If using liquid detergents, a programme without prewash must be selected. Pour the liquid detergent into the detergent compartment immediately before you start the programme. Your appliance incorporates a recirculation system which allows an optimal use of the concentrated detergent. Follow the product manufacturer’s recommendations on quantities to use and do not exceed the «MAX» mark in the detergent dispenser drawer.
Programme/ Temperature Type of laundry Options Description of the programme DRAIN For emptying out the water of the last rinse in programmes with the Rinse Hold or No spin option selected. Draining of water Max Load 3 kg SPIN Separate spin for hand washed garments and after programmes with the Rinse Hold option selected. You can choose the spin speed by turning the spin speed selector to adapt it to the fabrics to be spun. Drain and long spin Max.
2. To remove the siphon at the inside edge of the drawer for cleaning, you need to press it inwards and pull it upwards at the same time. Flush it out under a tap, to remove any traces of accumulated powder. When you put it back, press it downwards until you hear a distinct click. Cleaning the drawer recess Having removed the drawer, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess.
What to do if… Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the End pilot light blinks to indicate that the machine is not working: Problem • 1 flash: problem with the water supply. • 2 flashes: problem with the water draining. • 4 flashes: door open.
Problem Possible cause/Solution Unsatisfactory washing results: Too little detergent or unsuitable detergent has been used. • Increase the detergent quantity or use another one. Stubborn stains have not been treated prior to washing. • Use commercial products to treat the stubborn stains. The correct temperature was not selected. • Check if you have selected the correct temperature. Excessive laundry load. • Reduce the laundry load. The door will not open: The programme is still running.
Technical data Dimensions Width / Height / Depth 495 / 670 / 515 mm Electrical connection Voltage Overall power Fuse Frequency 230-240 V 1600 W 10 A 50 Hz Water supply pressure Minimum Maximum 0,5 bar (0,05 MPa) 8 bar (0,8 MPa) Level of protection against ingress of solid particles and moisture Water supply 1) IPX4 Cold water Maximum Load Cotton 3 kg Spin Speed Maximum 1000 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Warning! Never lift the machine by gripping it’s control panel, door, or detergent dispenser. Unpacking When supplied the washing machine is packed using a number of locking devices/ packing pieces to prevent drum and motor from damage in transit All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 1.
1. Connect the water inlet hose supplied with the machine to a tap with a 3/4" thread. Always use the hose supplied with the appliance. Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or furniture. Level the washing machine by raising or lowering the two front feet. If necessary, check the setting with a spirit level.
Water drainage The end of the drain hose can be positioned in three ways: Hooked over the edge of a sink using the plastic hose guide supplied with the machine. The drain hose can be connected directly into the pipe (e.g. beneath a washtub or sink), above the water trap. The drain hose must be arranged so that some part of it’s length is routed up to a level corresponding to the top edge of the tub and fixed in place there.
Information on the electrical connection is given on the rating plate on the inner edge of the appliance door. Check that your domestic electrical installation can take the maximum load required, also taking into account any other appliances in use. Connect the machine to an earthed socket. injury through failure to comply with the above safety precaution. The power supply cable must be easily accessible after installing the machine.
D Dometic WAECO International GmbH Hollefeldstraße 63 · D-48282 Emsdetten +49 (0) 2572 879-195 · +49 (0) 2572 879-322 Mail: info@waeco.de · Internet: www.waeco.de Dometic Austria GmbH Neudorferstrasse 108 2353 Guntramsdorf +43 2236 908070 +43 2236 90807060 Mail: info@waeco.at I Dometic Italy S.p.A. Via Virgilio, 3 I-47100 Forlì +39 0543 754901 +39 0543 756631 Mail: info@dometicwta.com AUS WAECO Pacific Pty. Ltd.