User manual

10
BASE ASSEMBLY
REAR VIEW, VACUUM TOILET
TROUBLESHOOTING GUIDE
1. Water will not stay in bowl.
2. Plastic ush ball will not close
completely.
3. Flush ball will not open.
4. Water does not shut off in
toilet (toilet overows).
5. Water does not enter toilet
bowl properly.
a. Loose clamp ring.
b. Improper seal around ush ball due
to dirt or debris on ush ball.
c. Worn or damaged seal.
d. Worn or damaged ush ball.
a. Too much friction between ush ball
and ball seal.
b. Water valve screws are too tight.
c. Defective spring cartridge.
a. Broken shaft.
b. Shaft not fully engaged in the
spring cartridge.
a. Not enough clearance between cam
strap and top of water valve cap.
b. Dirt lodged in water valve seal.
a. Insufcient water ow rate at toilet.
b. Water valve clogged.
c. Plugged rim wash holes in toilet.
a. Tighten clamp ring adjusting nut.
b. Inspect ush ball and seal for
foreign debris. Clean ush ball and
seal if needed.
c. Replace seal.
d. Replace ush ball.
a. Lubricate between ush ball and
ball seal with furniture polish (e.g.
Pledge
®
furniture polish).
b. Loosen screws slightly.
c. Check spring tension by pushing
ush lever down, then release it
suddenly. If lever does not snap
back into original position, replace
spring cartridge.
a. Replace shaft.
b. Put pressure on shaft from under
the ush ball (pushing into spring
cartridge) until it engages. You may
have to rotate ush ball slightly until
shaft lines up with square in
spring cartridge.
a. Adjust cam strap to have .02"
(.5mm) minimum clearance with top
of valve cap.
b. Disassemble and clean water
valve.
a. Check water ow rate at toilet. Rate
should be 2 gpm (7.6 lpm) at toilet.
b. Remove and clean screen located at
inlet of water valve.
c. Clean holes. If still a problem,
replace the toilet bowl.
Problem Possible Cause Service Instructions
VACUUM
BREAKER
WHITE CAP
HOSE
CONNECTION
VACUUM BREAKER/BOWL CONNECTION
® Pledge is a registered trademark of S.C. Johnson & Son Inc.