User manual

8
5000 SERIES
BASE ASSEMBLY
ADJUSTING NUT
FLUSH BALL
SPRING
CARTRIDGE
WATER VALVE ASSEMBLY
TOP VALVE CAP
FILTER SCREEN
WATER
VALVE
SCREWS
VALVE BODY
SHAFT
FLUSH PEDAL
BAND
CLAMP
BALL SEAL
BOWL
SEAL
5000 SERIES BOWL,
REAR VIEW
HOSE
CONNECTION
CHECK VALVE/
BOWL CONNECTION
TROUBLESHOOTING GUIDE
1. Water will not stay in bowl.
a. Loose clamp ring.
b. Improper seal around flush
ball due to dirt or debris on
underside of ball seal.
c. Worn or damaged seal.
d. Worn or damaged flush ball.
a. Tighten clamp ring adjusting nut.
b. Inspect flush ball and underside
of seal for foreign objects.
Clean under seal if needed (see
page 5).
c. Replace seal.
d. Replace flush ball.
Problem Possible Cause Service Instructions
REMOVING PEDAL COVER
1. To gain access to water valve,
press tab on back of pedal to
release pedal cover.
2. Pull cover away from pedal. Cover
snaps back into place.
For short-base model 5006, remove
two screws holding pedal cover in
place (not shown).
REMOVING PEDESTAL COVER
3. For tall models, remove screw
located under flush pedal.
4. Unsnap bottom and pull cover
away from pedestal. Model and
serial number label is located on
base.
1
3
4
2