Installation Guide

Fitting the camera CAM45
EN
16
Creating a through-hole for the camera connection cable (fig. b, page 6)
I
A
➤ Drill a hole with a Ø 16 mm at the previously marked duct.
➤ Deburr all drill holes that have been made in the sheet metal and apply rust-protection.
Screw on camera using self-tapping screws (fig. c, page 6)
A
➤ Drill the holes, with a Ø of 4 mm, at each of the markings.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw on the camera bracket using 5 x 20 mm self-tapping screws.
Fitting the camera
A
➤ Guide the camera cable into the vehicle interior.
➤ Slide the camera into the camera bracket.
➤ Fasten the camera loosely using the two screws M3 x 6 mm in the slots (fig. e, page 6).
➤ Provisionally align the camera, so that the lens is at an angle of approx. 50° to the vertical axis
of the vehicle (fig. f, page 7).
NOTE
If possible, use available openings, such as ventilation grilles, to feed the connection
cables through. If there are no existing ducts, you must drill a hole of Ø 16 mm.
NOTICE! Beware of damage
Check beforehand that there is sufficient space on the other side for the drill head to
come out.
NOTICE! Beware of damage
Self-tapping screws may only be fastened to steel metal with a minimum thickness of
1.5 mm.
NOTICE! Beware of damage
Only use the screws supplied to mount the camera. Longer screws will damage the
camera.
CAM45-IO-16s.book Seite 16 Donnerstag, 1. März 2018 10:19 10