Installation Manual

EN
Installing the refrigerator RUA5208X, RUA6408X, RUA8408X
20
Install the flue duct as follows:
➤ Make a rectangular opening in the outer wall of the vehicle (fig. k).
– The opening must be as wide as the flue pipe (fig. j 3, page 19).
– The opening must be high enough that the flue pipe fits through at a 45°
angle.
➤ Insert the coil (fig. j 7, page 19) in the flue pipe (fig. j 8, page 19) of the
refrigerator.
➤ Place the T-piece (fig. j 4, page 19) on the adaptor (fig. j 5, page 19) and the
flue pipe (fig. j 8, page 19) of the refrigerator.
➤ Direct the T-piece at an angle of 45° towards the rear wall.
➤ Attach the T-piece, adaptor and flue pipe with a screw (fig. j 6, page 19).
➤ Install the mounting plate (fig. l).
➤ Fill the opening with fire-resistant material (e.g. stone wool (fig. l).
I
➤ Slide the flue pipe at least 15 mm on the T-piece (fig. l).
NOTE
In some installation situations, it is possible that the flue pipe would
extend too far out of the vehicle in its installed state. Shorten the flue
pipe to the correct length if necessary.
1.
2.
k
min.
15 mm
1.
2.
3.
l
DometicRUA5208X6408X8408X_INM_4445102444_APAC(en)_xxxx-xx-xx.book Seite 20 Dienstag, 1. Dezember 2020 5:16 17