Installation Guide

Installing the refrigerator RUA6408X, RUA8408X

6.3 Making air inlet and outlet vents

➤ Make a cut out in the wall to fit an appropriate upper and lower vent system,

choose LS300 check the dimensions required for the vent. See chapter “Prepar-

ing the installation” on page 6.

➤ If the lower ventilation grille can not be installed flush to the door, make an air

inlet vent in the floor (fig. 2 4, page 8) behind the refrigerator near the gas

burner.

➤ Shield the end of the opening with a deflector to prevent sludge or dirt from

getting inside while driving (fig. 9).

If you have to use a roof vent instead of an upper wall vent:

➤ Cut out a section in the roof. Refer to the roof vent instruction manual for the

required dimensions. When doing so, observe the information, see chapter “Pre-

paring the installation” on page 6.

NOTE

At high ambient temperatures, the refrigerator can only provide its max-

imum cooling capacity if the optimum ventilation has been provided.

≥ 40 mm

RUA8408X-I-AU.book Seite 14 Donnerstag, 12. April 2018 12:16 12