Product Manual

EN
RUA5208X, RUA6408X, RUA8408X Troubleshooting
43
Faults and beeps
Faults are indicated on the display by highlighting the middle section with a red
banner and a code. The faults that terminate the complete cooling function are dis-
played on the screen in combination with a beep.
In case of multiple faults, the last fault is shown on the display. Underlying faults are
shown after the last fault is acknowledged.
The beep will last for 2 minutes and repeat every 30 minutes until the fault is restored.
Error type faults must be manually reset by pressing and holding the control knob
between 2 s and 4 s. Warning type faults reset automatically once the condition
passes.
The refrigerator does
not cool sufficiently.
The ventilation around the
cooling unit is not sufficient.
Check that the ventilation grille is
not obstructed.
The evaporator is iced up. Check whether the refrigerator
door is properly closed. Defrost
the refrigerator.
The temperature is set too
high.
Set a lower temperature.
The ambient temperature is
too high.
Remove the ventilation grille for a
while so that warm air can escape
quicker.
Too much food at once was
placed in the refrigerator.
Remove an item.
Too much warm food at once
was placed in the refrigerator.
Remove the warm food and leave
it to cool down before putting it in
again.
The refrigerator has not been
operating for very long.
Check the temperature again after
four or five hours.
Problem Possible cause Suggested remedy
RUA8408X-O-AU.book Seite 43 Montag, 1. Juli 2019 8:37 08