User manual

6
To defrost the refrigerator, follow these steps:
Turn off the refrigerator. (Press the ON/OFF
button (1) to ”OFF”.)
Empty the refrigerator.
Leave the drip tray under the finned evapo-
rator.
Leave the cabinet and freezer door open.
Defrost water runs from the drip tray
through a plastic drain water hose to the
outside of the vehicle.
When all the frost has melted - dry the inte-
rior of the refrigerator with a clean cloth and
replace ice trays and food.
Turn on the refrigerator and set the thermo-
stat to the coldest position for a few hours.
Place the food items back inside.
Remember to reset the thermostat to the
desired setting, usually at mid setting.
To defrost the refrigerator, follow these steps:
Turn off the refrigerator. (Press the ON/OFF
button (1) to ”OFF”.)
Empty the refrigerator.
Leave the cabinet and freezer door open.
Defrost water runs from a collector channel
to a receptacle at the rear of the refrigerator
where it normally evaporates.
Note! With a lot of defrost water, as a result
of heavy frost build-up on the freezer plate
and the cooling fins, move the plastic drain
tube in to a watertight bucket or container.
Access through the lower ventilation grill on
the outside of the vehicle. As the frost melts,
the water will flow into the container. Re-
place the drain tube to its original position
after defrosting.
Defrost water in the freezer compartment
should be mopped up with a cloth and when
the ice has melted - wipe the refrigerator
dry.
Turn on the refrigerator, place the food items
back inside but wait until the refrigerator is
cold before making ice cubes.
CLEANING THE REFRIGERATOR
Clean the inside of the refrigerator regularly to keep it fresh
and hygienic.
Never use detergents, scouring powder, strongly
scented products or wax polish to clean the interior
of the refrigerator as they may damage the surfaces
and leave a strong odour.
Soak a cloth in a solution consisting of a teaspoon of bicarbon-
ate of soda to half a litre of warm water. Wring out the cloth
and use it to clean the interior of the refrigerator and its fittings.
The exterior of the refrigerator should be wiped clean now and
then, using a damp cloth and a small quantity of detergent. But
not the door gasket, which should only be cleaned with soap
and water and then thoroughly dried.
The cooling unit behind the refrigerator should be cleaned with
a brush from time to time. Make sure that the refrigerator is
switched off when doing this!
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
5.
REPLACING THE BULB
To replace the bulb, follow these steps:
Remove the lamp cover.
RM 4605/RM 4805: Push the lamp cover backwards.
Replace the old bulb with an appliance bulb of the same
wattage (12V, max 10W).
Replace the cover.
HEATING CABLE
During the summer months of high tempera-
tures and humidity, the metal frame between the
freezer and fresh food compartments may have
water droplets forming. This refrigerator comes
standard with a 12V DC heating cable that will
evaporate the water droplets when they form.
To have the heating
cable on, you position
the switch located be-
neath the control panel
to I, see Fig. 2.
The heating cable can
be left on continuously
or only used when tem-
peratures require it.
The heating cable will draw 12V DC
power continuously when in the ON (I)
position. It should be turned off when
a charging source is not available.
TURNING OFF THE REFRIGERATOR
If the refrigerator is not to be used for some time:
Turn off the refrigerator. (Press the ON/OFF button (1)
to “OFF”.)
Shut off any on-board valve in the gas line to the
refrigerator.
Pull out the plug from the wall socket.
Empty the refrigerator. Defrost and clean it as described
earlier. Leave the doors of the refrigerator and frozen food
compartment ajar.
1.
2.
3.
1.
2.
3.
4.
CLIMATE-
CONTROL
SWITCH
OFF
ON
Fig. 2
RM 2355
RM 2455
RM 2555
RM 4605
RM 4805
m
K
RM 4605
RM 4805