User manual

15
With screws (see Fig. 20 and Fig. 22)
To mount the door panel, follow these steps:
Open the door 90 degrees.
On new refrigerators, the decoration strip
is taped inside the door; if installed on the
door, remove the door decoration strip (2)
by removing its three screws (1).
Remove the old panel.
Insert the new panel by inserting the vertical
edges into the grooves of the door frame (3).
Then, push the panel downwards so that the
lower horizontal edge of the panel (4) is fit-
ted into the bottom grove (5).
Put the decoration strip across the door so
that the gap is covered.
Secure the decoration strip with the three
screws removed in step 2.
Snap in (see Fig. 21 and Fig. 22)
To mount the door panel, follow these steps:
Open the door 90 degrees.
On new refrigerators, the decoration strip
are taped inside the door; if installed on the
door, remove the door decoration strip (2)
by gently pushing the four tabs away with a
flat blade screwdriver (1).
Remove the old panel.
Insert the new panel by inserting the vertical
edges into the grooves of the door frame (3).
Push the panel downward so that the lower
horizontal edge of the panel (4) is fitted into
the bottom grove (5).
Snap in the decoration strip (2).
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.
RM 2455
RM 2555
RM 4605
RM 4805
RM 2455
RM 2555
RM 4605
RM 4805
1
1
1
2
1
1
1
With screws
Fig. 20
Snap in
1
2
2
Fig. 21
3
3
4
5
Fig. 22