User manual

8
Do not connect any other electrical equipment or light-
ing to the refrigerator circuit.
The connections must be clean, tight and free from cor-
rosion. If not, a resulting voltage drop will cause a de-
creased cooling capacity.
! CAUTION
Do NOT operate the refrigerator on 12 volt when the
vehicle is parked. The amperage draw of the 12-volt
DC heating element can discharge a battery in a very
short time. The installation of a 12-volt DC operated
refrigerator requires a relay to be installed on the
tow vehicle or in the caravan. The relay will auto-
matically shut off the 12 volt DC power to the refrig-
erator when the ignition is turned off. (See fig. 9).
FIG. 9
Battery
Refrigerator
Switch key
Relay
Breaker
point
Ignition
coil
CHANGING DOOR SWING TO OPPOSITE
SIDE
 Remove the top hinge pin and lift out the door,
save the pin.
 Remove the lower hinge pin.
Move the hinge pin to the hinge bracket on the
opposite side of the refrigerator.
 Remove the hinge bushing and the latch retainer
on the top of the door, save the screw to the latch
retainer.
 Take a new hinge bushing and latch retainer (from
the parts bag placed inside the refrigerator).
The bushing and the latch retainer on the top of the
door should be shifted. Use the same screw to
fasten the latch retainer.
 Remove the travel catch on the upper hinge
bracket, save the screw; re-fasten it on the hinge
bracket at the opposite side.
 The lower hinge bracket that is not in use can be
removed and the screw holes covered by plastic
plugs (from the parts bag).
 Put the door on the lower hinge pin and close the
door, the door gasket keeps the door in position.
 Replace the top hinge pin.
 Check the travel catch to make sure it works
properly and that the door closes easily, and the
gasket seals well on all sides.
PANEL DIMENSIONS
MAX. THICKNESS 5/32" (4 mm)
REFR. MODEL HEIGHT WIDTH
TYPE MAX. MIN. MAX. MIN.
RM 2350 inch 25-9/32 25-3/16 19-5/8 19-17/32
mm 642 640 498 496
INSTRUCTIONS FOR MOUNTING THE
DOOR PANEL
The refrigerator is normally delivered without door panel.
The lower decoration strip and parts bag are taped in-
side the door.
Before starting the mounting work, check that the panel
dimensions are in compliance with those given in the
Table and the instructions are read thoroughly.
We recommend to mount the panel on the door before
the refrigerator is installed in the enclosure.
When mounting the panel, proceed as follows:
 Slide the panel from the bottom of the door into the
grooves on the vertical edges of the door .
 Push the panel upwards, take the two plastic panel
stops from the parts bag and put them in the two
holes at the lower door frame.
 Put the decoration strip across the door and fasten
it with three screws from the parts bag.