User manual

6
INSTALLING REFRIGERATOR IN
ENCLOSURE
NOTE: DO NOT install the appliance directly on
carpeting. Carpeting must be removed or
protected by a metal or wood panel beneath
the appliance, which extends at least full
width and depth of the appliance.
The refrigerator must be installed in a substantial enclo-
sure and must be level. When installing the refrigerator
in the enclosure, all areas within the recess in which the
refrigerator is installed must be sealed.
Make sure that there is a complete seal between the
front frame of the refrigerator and the top, sides and
bottom of the enclosure. A length of sealing strip is ap-
plied to the rear surface of the front frame for this pur-
pose. Also apply a sealing strip to the foremost floor of
the enclosure as shown in fig. 6. The sealing should
provide a complete isolation of the appliances combus-
tion system from the vehicle interior.
NOTE: Be careful not to damage the sealing strip when
the refrigerator is put in place.
Failure to follow the sequence in securing refrigerator in
enclosure can cause leakage between the frame and
cabinet.
When installing the refrigerator, the installer must block
the space between the storage cabinet and the top of
the refrigerator, otherwise heat will become trapped in
this space, making the top of the refrigerator hot, thus
reducing the efficiency of the unit.
Securing the Refrigerator
After the refrigerator is put in place, (insuring a combus-
tion seal at the front frame), the refrigerator is to be se-
cured in the enclosure with five screws (not included).
The screws have to be installed in the following order:
STEP 1: Four screws installed through the front
frame. See fig. 7.
STEP 2: One screw installed in rear base. See fig. 7.
In the parts bag there are plugs to be snapped in the
front frame to cover the four screw heads.
FIG. 6
LP GAS CONNECTION
The refrigerator is designed for operation on LP gas, the
pressure of which must be 2,7 kPa for Propane.
Check that this is stated on the data plate.
The refrigerator is NOT designed for operation on town
gas or natural gas.
The gas installation and servicing must be carried out
by an authorised person and conform to all relevant lo-
cal authorities.
The gas supply system must incorporate an approved
gas pressure regulator to maintain a supply pressure of
2,75 kPa.
! CAUTION
CHECK THAT THE GAS SUPPLIED TO THE RE-
FRIGERATOR IS AT THE CORRECT PRESSURE.
SEE THE REDUCING VALVE ON THE LP GAS
CONTAINER.
1
2
FIG. 7