Service manual

GENERAL INFORMATION
FOR MODELS RM2602
& RM2802
The refrigerator is equipped with an Once the low voltage has been cor-
energy selector system. The system
rected, the control system goes back
selects the most
suitable available to normal operation. To indicate
energy source. The selection will be that the control system is in a low
made with the highest priority to
volts and the lowest priority to
operation.
If the gas mode is chosen, the
will operate on gas only, even if
volts are present.
120
gas
unit
120
DC voltage condition the selector
mode
[ A/C GAS ] indicator will be turned
off. The interior light is unaffected
during the entire procedure.
The control system always requires
12 volts DC to be able to operate
on
ANY energy mode. Below 9.5
volts DC the control system will go
to gas with no thermostat control.
If the refrigerator does not succeed
in lighting on gas the first time,
turn unit OFF and then ON since
there might be air in the
lines.
A-12