Service manual

Bulletin #R60/7A continued
FREEDOM SERIES
RM 2802
(PDI) PRE-DELIVERY INSPECTION
PDI insures safe operation of Dometic refrigerators. The following
checks on each unit are advised before being operated by the consumer.
If each refrigerator is inspected according to these guidelines, you
can be assured of peak performance from your Dometic refrigerator.
1.
2.
3.
4.
ORANGE continuous light: Indicates gas ignition failure - no gas.
MAIN SWITCH
PUSH BUTTON: Green - indicates gas operation ONLY.
PUSH BUTTON: Green
- Gives energy selection between A/C and Gas.
NOTE: No 12 volt power selection possible.
OPERATIONAL TEST
3.
Disconnect 120 volt cord. The refrigerator
A.
B.
C.
D.
E.
Have 120 volt A/C supply available.
Be sure you have a good 12 volt battery supply.
Make sure gas valves, both at tank and rear
of refrigerator, have been turned on.
should now light on gas.
If this is not
accomplished in approximately 3 minutes,
the Flame Failure Light will come on.
1
Turn ON/OFF switch to “ON” position.
To correct this turn main switch OFF
and the back to ON. The green A/C flame
light should come on again.
Set
1.
2.
thermostat to “NORMAL” position.
Plug coach 120 volt cord into 120 volt
outlet.
Green A/C flame light
#4 should be on.
4
AC
4.
To check GAS ONLY operation, push #3,
Green Flame Light.
The system will
then operate on gas regardless if 120 volt
power is present.
If unit fails to light,
Flame Failure Light will come on. Turn
OFF main switch and then turn back to
ON. Unit should now be lit on GAS.
3
A-l l-15