Service manual

Bulletin

#R58/7A

continued

Lastly, the moisture shield kit has been enclosed and can be

installed to prevent corrosion

damage caused by water or car wash solution being sprayed into the back of the refrigerator

through the vent louvers.

The circuit board compartment should be sealed in the following

manner:

Install the shield under the bottom mounting bracket of the cooling unit. See the drawing

below by model number. Seal the top edge with the foil tape supplied.

Seal around the conduit,

where it goes into the circuit board compartment, with putty

tape supplied or a silicon sealant can be used.

FOIL TAPE

ALONG TOP

Model 763

Model 663

NOTE: The earlv series

only

which has the

rectangular boiler

enclosure, requires

that the shield be bent across the middle

slightly (I),

with a little more angle on

the upper tab (2).

Models with the interior light conduit

(3) coming out of the top of the circuit

board housing may require a trimmed

slot and putty tape around the conduit

and slot.

Caution should be used when washing the vehicle

and avoid spraying water onto the refrigerator.

A-11-8